| |
Free run, External trigger(Hardware, Software) |
Maximum Frame Rate (Full Scan) |
- |
- 8Bit Output |
56.0 fps |
- 10Bit Output |
56.0 fps |
- 10bit Packed output |
56.0 fps |
- 12Bit Output |
56.0 fps |
- 12bit Packed output |
56.0 fps |
ADC bit width |
12 bit |
Video Format |
8/10/12 bit output (Support packed on 10bit, 12bit) |
Noise Level |
- |
- 8Bit Output |
<= 3 LSBs (Gain 0 dB) |
- 10bit / 10bit Packed Output |
<= 12 LSBs (Gain 0 dB) |
- 12bit / 12bit Packed Output |
<= 48 LSBs (Gain 0 dB) |
Sensitivity |
1020 Lux |
Exposure Time |
- |
- 8Bit Output |
25.2 seconds to 47 seconds |
- 10Bit Output |
25.2 seconds to 47 seconds |
- 10bit / 10bit Packed Output |
25.2 seconds to 47 seconds |
- 12bit Packed output |
25.2 seconds to 47 seconds |
- 12bit Packed output |
25.2 seconds to 47 seconds |
Gain |
-40dB to 12dB |
- Analog (Gain) |
0 to 20.8 dB |
- Digital (Gain) |
0 to 6 dB |
Black Level |
- |
- 8Bit Output |
0 to 31 |
- 10bit / 10bit Packed Output |
0 to 127 |
- 12bit / 12bit Packed Output |
0 to 511 |
White Balance Gain |
-40dB to 12dB |
ROI (AOI) |
Horizontal: 64 to 2448 (2432 on Packed) / Vertical: 32 to 2048 Adjustable Steps for offset: 16 pixels in horizontal direction (64 pixels on Packed) / 4 lines in vertical direction Adjustable Steps for offset: 4 pixels in horizontal direction / 4 lines in vertical direction |
Gamma |
Gamma Table =0.1 to 4.0, Default = 1.0 |
Binning |
N/A |
Decimation |
Individual x2 Horizontal, Vertical Decimation |
Image Flip |
Horizontal / Vertical / Horizontal and Vertical / OFF |
Pixel Defect Correction |
Up to 64 points |
Auto Image Control |
- |
- Auto Exposure |
Support (Default: Fix 27.5 mseconds) |
- Auto Gain |
Support (Default: Fix x1 |
- Auto White Blance |
Support (Default: Manual) |
Operational Mode |
Free-run / Edge-preset Trigger / Pulse width Trigger / Start Stop Trigger |
User Setting Storage |
Support |
Communication |
Via USB3.0 bus |
Interface |
USB 3.0 Super Speed (USB 3.0 Micro B) |
Protocol |
USB3 Vision® 1.0.1, GenICam Standard Version (SFNC 2.2, PFNC 2.0) compliant and Sentech’s unique protocol (on Normal SDK, Trigger SDK) |
Input / Output |
Three GPIO, One Camera Hardware Reset |
Power |
- |
- Input Voltage |
+5V(typ.) (This conforms to the USB standard |
- Consumption |
Max: 3.4W, Typ: 2.8W |
